Thread: How to make BlackBerry 10 apps using Cascades

Is there a guide to show How to make BlackBerry 10 apps using Cascades?

I would love to learn . If possible, a guide that actually makes an app other than Hello World lol.

Thanks

I normally don't direct our members to other sites. But Brian Schierer has a great site for Native Cascades developing. Lots of tutorials. See here... BlackBerryOS.com - Get Started Developing For BlackBerry At The BBcascades Blog!

Cool. Will take a look.

Thanks

I just use Github examples BlackBerry has posted.

I take what I need.

Needed to connect data to an option in an Segmented Control, looked at the RSS News Feed example.

So I was playing around with QNX and the VM for a while. Trying the simple hello world example in QNX. The only thing is that I cannot figure out what is not working. The build works, the setup of QNX is correct. Configured the targets and configured the package signing and debug tokens = done. The target is connected to the VM's IP address, but when I right-click the project in the project explorer, then run as-> Blackberry C/C++ Application, there are no target options which I can choose from. When I try to delete the target, and remake a new target, it gets created, but then it shows, then it disappears. It then shows on the project explorer.

Not sure what I am doing wrong. Was following the beginner's guide (via n4bb). This is where I am stuck now. I've attached a screenshot so hopefully you can help me out please!

Thanks

Thanks to the help of Brian Scheirer, I got it working! -Check that the build config is set to simulator. Device is default.

Time to start learning hopefully lol